Onguard Kinglet Gate 57H x 48W
$208.93 – $302.50
- Aluminum Gate
- Pressed Spear Tops
- Welded Frame
- Self Closing Hinges Included
- Double Pickets
- Gravity Latch Included
- Additional information
Onguard Kinglet Aluminum Gate 57H x 48W
This Onguard Kinglet aluminum gate is made to fit a 49.5 inch opening between posts. Kinglet gates have a pressed spear top rail and double pickets to match the 57 inch tall Kinglet aluminum fence panels. Kinglet has 1 5/8 inch picket spacing, which is good for pet fence and privacy fence. Onguard gates have a welded frame for strength and durability. The aluminum pickets slot down through pre-cut holes in the middle of the horizontal rails. Onguard gates are powder coated for a maintenance free, rust proof finish. The finish is between shiny and matte. This pet gate is a great way to keep your pets safe, while keeping other animals out.
Decorative finials are an option instead of the standard pressed spear tops. You would need 9 decorative finials to replace the pressed spear tops on this gate. Onguard will cut the pressed spears off the fence panels to allow installation of the decorative finials.
Aluminum Pool Fence Gates
Onguard Kinglet at 57 inches tall is made to make most local pool codes. Most pool codes require 45 inches between the two innermost horizontal rails. This gate has a welded U frame so no cross bar is needed to keep the gate from sagging. The bottom horizontal rail is dropped with no pickets extending past it. This gate does not have a pet panel option so it will make most pool codes. Check your local building codes for pool code requirements in your area. Purchase a magna latch or magnetic latch to make this gate pool code compliant.
Kinglet Arched and Double Gates
Arched gates are an option for Onguard Kinglet gates and are made up to 72” wide. You can create double gates by ordering two of the same gate, and making a note during checkout which gates are double gates. Continuous Arched gates are used to create a single arch over the span of a double gate. Purchase a drop rod to keep one gate closed, and pull out the drop rod when you want to open both gates.
Installing a 57H x 48W Kinglet gate
Onguard gates are true to size, so you will need to add 1.5 inches per gate leaf for the hinges and latch between gate posts. Install the hinges and latch with the provided powder coated stainless steel self tapping screws. If you are hanging this gate between columns that are wider than 2 inches, you will have to install the hinges on the corner of the column. To hang the gate in the middle of a column, you will need to build a shim that will allow the hinges to be attached so the gate swings open. If possible, it is recommend to use blank gate posts when installing between columns. Our help articles and Onguard installation guides provide more information on installing gates.
- Powder coated
- Aluminum gate
- Made overseas
- Welded frame
- Gravity latch included if no magnetic latch is purchased.
- Self closing hinges included
- Limited lifetime warranty
- Arched gates available
- Used with Onguard Kinglet 57H fence panels
Fence panels, posts, and accessories are sold separately.
FenceTown help articles contain more information on Onguard aluminum gates.
|Dimensions||48 × 57 in|
Black, Bronze, White